Joel O'Connor

Turning on this setting allows the camera time to be set via NTP to be correct with DST also enabled, but then the stream errors start.Turning this off forces NxWitness to set the camera time which...

The solution to this issues was found in another thread linked below :) https://support.networkoptix.com/hc/en-us/community/posts/6788218376983/comments/6794563238423 

Thank you! We have been having this issue which was always resolved by a NxWitness server reboot. This solution seems to have resolved the issue from re-occurring.

Server do share all the same cameras. As reference, this client wanted a backup server which ran in parallel to the primary server. This way if one of the servers was stolen or failed, they would h...

Thank you for the replies, I have confirmed these settings are both turned off and have been for quite some time.Would the only solution here be to setup a firewall rule so each server cannot see e...

Hello Anderson Chang, we have also been experiencing this same issue where we receive a conflict error every minute, even though all the auto discovery and optimization is off on the second server....