Joel O'Connor
Liquid Automation Auckland, New Zealand
- Total activity 15
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 5
Activity overview
Latest activity by Joel O'Connor-
Joel O'Connor commented,
Turning on this setting allows the camera time to be set via NTP to be correct with DST also enabled, but then the stream errors start.Turning this off forces NxWitness to set the camera time which...
-
Joel O'Connor created a post,
Hikvision time sync
AnsweredHello, Since daylight savings started here in New Zealand I have been struggling with one site where we have a single Hikvision camera who's time is 1hr out from the server. The server OS is set c...
-
Joel O'Connor commented,
The solution to this issues was found in another thread linked below :) https://support.networkoptix.com/hc/en-us/community/posts/6788218376983/comments/6794563238423
-
Joel O'Connor commented,
Thank you! We have been having this issue which was always resolved by a NxWitness server reboot. This solution seems to have resolved the issue from re-occurring.
-
Joel O'Connor commented,
Server do share all the same cameras. As reference, this client wanted a backup server which ran in parallel to the primary server. This way if one of the servers was stolen or failed, they would h...
-
Joel O'Connor commented,
Thank you for the replies, I have confirmed these settings are both turned off and have been for quite some time.Would the only solution here be to setup a firewall rule so each server cannot see e...
-
Joel O'Connor commented,
Hello Anderson Chang, we have also been experiencing this same issue where we receive a conflict error every minute, even though all the auto discovery and optimization is off on the second server....
-
Joel O'Connor created a post,
Bosch IP 3000i constant no signal or green images. Plus no motion events
AnsweredHello, we have a site with 16 Bosch cameras. Nx is not picking up the motion for all of these. Some have required us to tick "Keep camera stream and profile settings", which can sometimes help to h...
-
Joel O'Connor created a post,
Showreel Performance and suggestions
AnsweredHello :) Recently we have had a few clients wanting to display up-to 32 cameras on 4K displays around their home and workplace. We have been doing this through Showreels on the NxWitness client but...