Daiki Kato
- Total activity 62
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 17
Activity overview
Latest activity by Daiki Kato-
Daiki Kato commented,
Hi Wendy Chuang, I'm really sorry.There was an error in the camera settings, which meant that it could not be authenticated.It worked fine with Nx5.1.1.37512.
-
Daiki Kato commented,
I'm sorry, there may be an error in the settings, so I will check again and get back to you.
-
Daiki Kato commented,
Hi Wendy Chuang, Norman-Nx-Support If you think it would be better to make a separate post about "i-PRO's WV-S1135VUX", please let me know.
-
Daiki Kato commented,
Hello, "i-PRO's WV-S1135V" can now be authenticated with Nx5.0.0.35745 or later, but "i-PRO's WV-S1135VUX" cannot be authenticated. Could you also check this camera?The version of Nx I'm currently ...
-
Daiki Kato commented,
Hi Andrew Sharrem, The camera firmware is up-to-date, and resetting did not resolve the issue. However, it successfully started working with the workaround you provided. Thank you very much.
-
Daiki Kato created a post,
A specific ONVIF camera is repeatedly connecting and disconnecting
AnsweredHi, I am using an ONVIF camera named "JS-CW1028". It was working fine until Nx version 5.0.0.35745. However, after Nx version 5.0.0.35745, the camera started to repeatedly connect/disconnect at int...
-
Daiki Kato created a post,
Amount of data written to syslog in Nx 5.1
Hi, I just started using Nx 5.1 and it writes quite a lot to syslog even during normal times. I want to see the behavior of other libraries, so I set the syslog level to "informational". It is easy...
-
Daiki Kato commented,
Hi Norman-Nx-Support, Thank you for the quick answer. And thank you for always helping me.
-
Daiki Kato created a post,
Is it possible to change the resolution of the USB camera?
AnsweredHi, Is it possible to change the resolution of the USB camera?For IP cameras, it can be changed from "Camera Settings" -> "Advanced", but for USB cameras there is no "Advanced" tab.I can change "Re...
-
Daiki Kato commented,
Hi Norman-Nx-Support, Thank you for your reply. I am asking the customer to check if there is an nx_ini directory. I will report the results as soon as I know them.