RAID5 and Failover Compatibility Issue in Nx System Calculator
Completed
I'm trying to make a design proposal to an important customer
However, there is a problem in the design process
I'm designing it through the Nx System Calculator
Design a system with RAID5 and Failover
The following message came out
RAID slows down recording speed and server cant record all the video from assigned cameras with RAID in failover mode
This sounds like a story about not running RAID5 and Failover at the same time
In our country, for the stability of data in most VMSs
RAID and failover are used at the same time
Can you check this out? In Nx
Can't I use RAID5 and Failover at the same time?
-
Hi dongju Yun,
Yes, you can absolutely use failover and RAID within the same system. Please keep in mind that the calculator makes certain assumptions about performance and capacity that may not fully align with your current hardware setup or its capabilities.
I'll share your email address with Shaum Chen, our presales engineer for your region. He’ll reach out to you directly to help with a hardware assessment and ensure the configuration meets your specific needs.
With kind regards.
0 -
To Norman
Thank you for your reply
However, we would like to provide this customer with the earliest possible design answers
I want to give it to you
Thank you again
From Dongju
0 -
Hi dongju Yun,
I have access to your email address, and our presales team will reach out to you as soon as possible.
0
Post is closed for comments.
Comments
3 comments