PTZ Tour setting
Completed
Hi.
Thank you for nx's support.
We are a partner of network optix, and while testing the product, a question arose.
The operating environment is:
Version: 5.1.4.38659
OS: Windows 11 Pro
The user manual explains:
"The same position should not be used consecutively or as both the first and last position."
What's the reason?
When I tested, it was possible to set the same positions consecutively or with the first and last positions being the same.
thank you.
-
Thank you for your post.
We are confirming with our product documentation team as to why this is documented and will reply again once we've heard back.
Thank you.
0 -
Hi cgjeon,
It took some time to review the source code, and it appears that the note in question is outdated and no longer relevant. I've recommended to our team that we either remove or rephrase it.
The only issue I found is that when there are consecutive positions, an additional delay occurs during the tour. However, this is considered an accepted behavior, as it is unlikely that users will intentionally configure consecutive positions in a tour.
Best regards.
0 -
Hi Norman
Thank you for reviewing the content. my question was solved Thank you.0
Post is closed for comments.
Comments
3 comments