Reolink camera not showing web interface in Camera Settings

In Progress

Follow

Jeff Jones

• January 13, 2023 17:47

I have ReoLink camera RLC410W that is only detected when I manually specify port 8000. Port 80 is where the web interface is. After the camera is added the Web Page tab in camera settings tries to open port 8000 giving just a bunch of XML data.

Is this just a screwed up ONVIF profile in the ReoLink? Is there some way we can override the web page?

0

• 

  Norman - Nx Support

  • January 16, 2023 08:35

  Hi Jeff Jones,

  We use the port of the discovery, for most device this would be 80.

  Some camera use a different port for the service, and this will be the port that is shown in the webpage tab.

  Not sure if there is a workaround possible. Would it be possible to provide remote access to such a device through port forwarding, so we can add it to our test environment for further investigations?

  0

  Comment actions Permalink
• 

  Jeff Jones

  • January 16, 2023 20:58

  Yes. I can probably setup access to that camera.

  0

  Comment actions Permalink
• 

  Norman - Nx Support

  • January 17, 2023 09:55

  Thank you Jeff Jones. 

  I have created a support ticket on your behalf, so you can share the credentials privately.

  0

  Comment actions Permalink

Post is closed for comments.