Support for PTZ Telemetry- Bosch Encoder- Multi 4000

Answered

Geoff Mckay

December 15, 2022 14:45

Is there any way to get PTZ functionality on this device?  Supported list shows that PTZ is not available and we have asked that it be enabled.

Since the device is ONVIF S compliant , should it not operate 'out of the box'?

1

• 

  Norman

  • Network Optix team

  May 24, 2023 12:54

  Dear Geoff Mckay,

  I apologize for the delay in responding to your request. It seems that we inadvertently missed it in our community.

  In case PTZ controls are supported in Onvif, they should work in Nx as well. If you can operate through the Onvif commands, and they don't work in Nx, further investigation is required.

  Best regards.

  0

Post is closed for comments.