Daiki Kato
- Total activity 65
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 1
- Subscriptions 18
Posts
Recent activity by Daiki Kato Sort by recent activity-
Support for Ubuntu 24.04 LTS?
AnsweredHello, Are there plans to support Ubuntu 24.04 LTS? If so, when can we expect the application to be compatible?
-
A specific ONVIF camera is repeatedly connecting and disconnecting
AnsweredHi, I am using an ONVIF camera named "JS-CW1028". It was working fine until Nx version 5.0.0.35745. However, after Nx version 5.0.0.35745, the camera started to repeatedly connect/disconnect at int...
-
Amount of data written to syslog in Nx 5.1
Hi, I just started using Nx 5.1 and it writes quite a lot to syslog even during normal times. I want to see the behavior of other libraries, so I set the syslog level to "informational". It is easy...
-
Is it possible to change the resolution of the USB camera?
AnsweredHi, Is it possible to change the resolution of the USB camera?For IP cameras, it can be changed from "Camera Settings" -> "Advanced", but for USB cameras there is no "Advanced" tab.I can change "Re...
-
Prompted to restart the NxWitness Client
AnsweredHi, When the camera image is displayed on the NxWitness client for a while, the following dialog appears and prompts you to restart the client. It says "Failed to connect to server" and says "You ...
-
Understanding Linux Package Versioning
CompletedHi, I am using Linux ARM64 version of Nx Witness Server.The deb package information (control file) of v5.0.0.35270 and v5.0.0.35745 are as follows and are indistinguishable. Package: networkoptix-m...
-
Nx 5.0 Auto-discovery does not recognize USB cameras
AnsweredHello, Nx 4.2 recognizes the USB camera with Auto-discovery, but Nx 5.0 does not.If you added a USB camera to the camera list in Nx 4.0 and updated to Nx5.0, you can see the image of the USB camera...
-
About the behavior of "Interval of action"
AnsweredHello, If "Interval of action" is set for Action, the event that occurred during the interval will be executed at the end of the interval as shown below.Is there a way to prevent the action at the ...
-
Nx 5.0 Auto-discovery not working properly with certain cameras
AnsweredHello, Auto-discovery doesn't work well with certain cameras in Nx 5.0.Even if I set Credentials, it remains "UNAUTHORIZED" and I cannot see the camera image.The camera that confirmed the phenomeno...
-
Sending the https REST API using the curl command causes an unusual increase in CPU load
AnsweredHiSending the https REST API to Nx Witness Server using the curl command causes an unusually high CPU load. A single transmission increases the CPU load by about 18%. When run 6 times in a row, the...