Bosch OnBoard Relay Config changing on NX server restart



1 comment

  • Avatar
    Norman - Nx Support

    Hi Joshua Geaney,

    There is a known limitation for the Bosch firmware, meaning the if both media and media2 were requested by the server it might influence the camera. 

    So please, check if there is new firmware for the camera that resolves the issue. If that isn't the case, you can disable Media2 requests in the Expert tab of the Camera Settings menu.

    If you disabled the Media2 requests, the I/O settings should be unaffected.

    If this remains an issue, please do the following:

    1. Assure all settings are made in the device.
    2. Start Wireshark with the camera IP address as host filter as described HERE.
    3. Reproduce the issue and confirm that the settings were cleared.
    4. Stop and save Wireshark.
    5. Share the Wireshark file for further investigation.
    Comment actions Permalink

Please sign in to leave a comment.