Hikvision - Getting way too many - Connection to camera (primary stream) was unexpectedly closed. on multiple sites!

Answered

Comments

5 comments

  • Avatar
    Paul Pittaway

    I am getting similar issues with all of my site. I was initially told it was probably a wiring issue. To test this I setup a small site at home with only 4 Hik cameras and wiring which was easily testable. The same problem occured. I just stopped the system from sending these message in the end.

     

    0
    Comment actions Permalink
  • Avatar
    Norman - Nx Support

    Hi Alex Pavlakis and Paul Pittaway,

    I hope this message finds you well. While reviewing our community discussions, I noticed that there hasn't been a response from other community members regarding your query. Could you please confirm if your question is still relevant? If so, I'd be more than happy to explore ways we can assist you.

    Best regards.

    0
    Comment actions Permalink
  • Avatar
    Dan Warne

    I’m having this problem too with my hikvision cameras.

    0
    Comment actions Permalink
  • Avatar
    Norman - Nx Support

    Hi Dan Warne,

    Please check THIS support article for some background information about such network issues.

    What typically happens when a device is unexpectedly closed, is that the camera can't keep up in the communication between mediaserver and camera, most likely due to a header buffer overflow on the camera side, but this should be confirmed with a package analysis, for example with Wireshark.

    Often this issue can be reduced or eliminated, by reducing the load on the camera, by reducing the image resolution and/or frame rate and/or quality. The issue should be resolved by the camera manufacturer, often by increasing the header buffers (if that was the culprit) in the firmware of the cameras.

    0
    Comment actions Permalink
  • Avatar
    Dan Warne

    Thanks Norman. 

    0
    Comment actions Permalink

Post is closed for comments.